Amana Tool DRB-240 CNC Polycrystalline Diamond (PCD) Tipped Compression Up/Down Shear R/H Direction 2+2 Flute x 1/2 Dia x 3/4 x 1/2 Shank Router Bit
- Diamond is the hardest material on the earth. Polycrystalline Diamond (PCD) tooling is manufactured in a high-temperature and high-pressure laboratory that fuses diamond particles onto a carbide substrate, which allows the diamond to be brazed onto a tool body.
- If you’re looking for the ultimate in tooling you’ve found it! Amana Tool®'s PCD tipped compression CNC router bits will groove joint and rabbet a wide variety of tough abrasive materials including composites, particleboard, MDF (both raw or with melamine), veneer and hardwoods. The cutting edge lasts much longer than carbide for extremely long life.
- Multipliers for different materials:
- Chipboard without coating: Max RPM x 1.1%
- Cross grain veneer: Max RPM x 0.7%
- MDF: Max RPM x 0.8%
- Excellent for Cutting:
- Aluminum
- Aluminum Composites
- Aluminum Composite Material (ACM)
- Composites
- Composite Panels
- Custom Composite Materials (CCM)
- Fiberglass
- Fiberglass PCB Board
- Fiberglass Reinforced Composites
- Fiber-Reinforced Urethane
- Fiber-Reinforced Structural Foam Floors
- Hard and Soft Wood
- Lightweight Composites
- MDF
- Plastic
- Benefits of Diamond Technology
- Harder cutting edge provides higher resistance to wear
- Cut thousands of feet more than carbide without changing tool saving setup time
- Optimized machine tool efficiency
- Quality of finish is often significantly improved
- PCD Up/Down Shear Compression Speed and Feed Chart
| Cutting Diameter | 1/2 |
|---|---|
| Shank | 1/2 |
| Cutting Length | 3/4 |
| Overall Length | 2-3/4 |
| Number of Flutes | 2+2 |
| Maximum RPM | 24000 |
