Amana Tool 55312 Carbide Tipped 45 Deg Laminate Miter Joint Undercutter Assembly 1-3/8 Dia x 1/4 x 1/4 Inch Shank
- Eliminate that dark line at the edge of a counter or other laminate-covered surface. With this bit assembly, the laminate cemented to the substrate can be trimmed and mitered in one pass. Then a pre-mitered edging strip can be applied. The resulting seam is clean and crisp. Not intended for use in a laminate trimmer.
- a. Laminated top is 'under-cut', as shown.
- b. Apron laminate is pre-cut at 45.°
- c. Adhere pre-cut laminate for a perfect fit. A fine file
- may be used to remove the sharp edge after joining.
| Replacements | 47708 |
|---|---|
| Cutting Diameter | 1-3/8 |
| Shank | 1/4 |
| Cutting Length | 1/4 |
| Overall Length | 2-3/8 |
| a° | 45° |
